Page 1 of 1

Accept Agreement - Possible Bug

Posted: 02 May 2007, 14:06
by SilentSniper
I am trying to run & install a .bin file, I am new to linux but run it by ./hlds.bin.
When i do, it comes up with an agreement, at the end it has: Enter 'yes' to accept this agreement, 'no' to decline.

When i enter 'yes' on its own, it gives me: y y y y y y y y y y y y y y y y. on new lines and will not stop adding more, so my IE7 crashes.

Is there any other way i can get past the agreement? I have fully read it by now, and the amount of time i have tried many other ways, i think i now have it graphicaly loged in my head word for word.

Best Regards
Ant

Posted: 03 May 2007, 11:19
by Sarah
Sounds like you are trying to run something that reqiures a response, interactively in the cse virtual console, which you can't do. You'll have to actually do it in ssh.

Sarah

Posted: 03 May 2007, 17:59
by SilentSniper
Thank You for your response.

Posted: 05 May 2007, 15:48
by SilentSniper
How can i do it in SSH?

I have tried everything in the panel.

EDIT:

My bad. I have now got PuTTY but cant connect for some reason, how do i find out what port the SSH is running on?

The Key's have been placed in.

Thanks

Posted: 07 May 2007, 21:12
by shannons
usually port 22 but if you cant connect to this port you may have to contact your provider and see what port it is

Posted: 08 May 2007, 13:53
by SilentSniper
It is my server, newly brought. But im used to Linux, how can i find out what the port is?

EDIT: Found the port, and changed it to one that was not already in use (The one it was trying was already in use). I Restarted the OpenSSH and it started perfectly. I connected and it asked for the "Login as: " I have tried root and others that i can get into the WHM with, but did not work, i got a error, "No supported authentication methods available".

Has anybody got any clues as to why this is?

Thanks in advance.

Posted: 10 May 2007, 11:53
by shannons
make sure your using ssh v2 not telnet or ssh v1